Request a quote, need project consultation or ask a question.
Industry Specialist - Years of Experience
Call direct at
Berm Builder – Around Machinery or Equipment
Build a barrier around machinery or equipment that is permanently mounted or cannot easily be moved
Most of our spill containment products are designed to be put in place and then have the potential offending “spillers” placed in or on the containment unit. But large, heavy or previously secured/bolted down equipment or machinery can make that very difficult or impossible.
The Ultra-Berm Builder solves that problem. This component system can be built to just about any size and/or shape that might be needed for your spill containment application.
The floor must be clean of debris. Any build-up of grease and oil must be removed. Failure to do so may result in premature failure of The Ultra-Berm Builder® sealant.
To apply The Ultra-Berm Builder® over frost cracks and form separations, fi rst fi ll these areas with caulking.
Apply 2 continuous beads of caulking on the bottom of the The Ultra-Berm Builder® approximately 1” in from its side and ends, along its entire length.
Place The Ultra-Berm Builder® and apply pressure to its entire length to seal it to the floor. Note: To ensure proper sealing on uneven surfaces, you may need to apply extra sealant and also more direct pressure .
To add sections or attach corners to the The Ultra-Berm Builder® , apply vinyl adhesive to the built-in vinyl cover and the end of the berm. Then mold the vinyl cover over the berm end and hold in place (approximately 30 seconds).
If it has been stored coiled, let the Ultra-Berm Builder® lie fl at for 2 hours before installing it.
Let the Ultra-Berm Builder® cure (sealant and glue) for at least one hour before use.
To cut the Ultra-Berm Builder®, use a utility knife along with a straight edge.
To remove the Ultra-Berm Builder®, scrape with a flat-blade shovel and use silicone remover to clean caulking from base.
The Ultra Containment Berm Rapid Rise model is designed to save precious response time in the event of a major spill. As the name suggests, the berm rises rapidly in case of a spill and hence there is no need for you to build support structures or walls around the spill to contain it. This ready to go containment berm is EPA and SBCC compliant and is available in many sizes.
[Transcript] The Ultra Containment Berm Rapid Rise model provides a security of an effective spill containment berm and the convenience of an almost completely flat sidewall. Use this model for quick and easy spill containment for drums, IBCs, pump trucks and other vehicles frac tanks and other large containers. Once yo...